news center
How to extend the service life of bearings
2016-07-12
According to statistics, about one-third of the damage to bearings is caused by fatigue loss of components, one-third of the damage is due to poor lubrication during daily use, and the remaining one-third is caused by contaminants entering into the be…
Three Steps on How to Install Tapered Roller Bearings Properly
2016-06-30
Tapered roller bearings are separable bearings. The inner and outer rings are separated. You can press the inner ring retainer assembly on to the shaft. When you press the sleeve, you should place one end of the sleeve on the end face of the outer rin…
How often does the grease of the slewing bearing be filled?
2016-05-27
First of all, after installing the slewing bearing according to the correct steps, it is necessary to fill in an appropriate amount of grease. There is one thing to pay attention to is to rotate the slewing bearing while filling, so that the grease ca…
Inspection method of radial clearance
2016-04-28
Sensory method1. With hand-rotating bearings, the bearings should be stable and flexible without jamming.2. Shake the outer ring of the bearing by hand, even if the radial clearance is only 0.01mm, the axial movement of the uppermost point of the bear…
Bearing clearance
2016-03-24
Bearing internal clearance refers to the total distance of radial movement of one bearing ring relative to another bearing ring (radial internal clearance) or the total distance of axial movement (axial internal clearance).Working clearance refers to …
